Silk Papermaking using an Adhesive Medium

1. Protect surfaces with plastic sheeting and place 1 sheet of the netting on top of it.
2. Dissolve adhesive in a jug or bowl of water. The best method is to add the powder to very hot water, then continue mixing gently until it has cooled. Start with half the
   final amount of hot water, add the powder, then top up with cold water. If you don't mix long enough you will find a slab of gelled methocel at the bottom of the container later.
3. Pull off a small handful of silk fibre. Hold it firmly with the heel of one hand and pull out lengths of fibre approx. 3-4cm wide and 6-8cm long.
4. Leaving a border around your netting, start at the top right hand corner and lay down chunks of fibre in a row, overlapping each piece as you go. Continue until you have created a row approx. 30cm wide.
5. Begin another row overlapping the fibres from the previous row.
6. Continue until the fibres cover an area of approx. 30cm x 20cm.
7. Cover fibres with the second sheet of netting
8. Pour some of the prepared glue solution onto the centre of the netting and work it into the fibres using a circular motion.
9. Using your fingers push the solution to the edges of the 'paper', adding more when necessary. Intermittently, carefully lift the back netting to ensure the fibres are wetted all the way through.
10. You can remove the top netting from the 'paper' prior to drying it, (or leave it in place to add texture to the surface). Remove netting slowly from one corner and carefully release fibres that have adhered to it. Place paper on a cake cooling tray to dry flat and allow circulation of air.
11. Finally, lift the corner of the back netting from the dried paper and remove slowly.

Silk Papermaking using Sericin

Any silk fibre which contains the original sericin ‘glue’, is the basis of a paper. Gummy Reeled Silk, Throwsters Waste, Cocoons and Carded Cocoon Strippings still retain the naturally occuring sericin which maintains the structure of the silk cocoon. The ‘glue’ can be activated by spreading the fibres on baking parchment, spraying with water, covering with another sheet of parchment and then ironing on a medium setting until the fibre is dry. This image shows hand-dyed Throwsters Waste 'paper'.

Try this:

1. Spread a layer of cocoon strippings, carrier rods or throwster’s waste onto baking parchment. Add coloured fibres of silk, wool or cotton, sequins, threads, leaves, dried petals, in fact you can add anything which withstands a little heat. The paper shown here, has been created using Carded Cocoon Strippings and Carrier Rods, it has been coloured with silk paints and gold Jacquard Lumiere paint.
2. Spread fibres in a light layer over the top to hold the decoration and spray lightly with water. If you are using undyed fibres, spray silk paint onto the mass to add colour, before ironing.
3. Iron over a second piece of parchment on a ‘medium’ setting until the fibre is dry and not sticking to the paper. Peel off when dry.
4. You can colour the paper with dye or use iron-fix silk paints.